However ive read that when a h beam distorts or bends it does so much slower and in a more controlled way than an i beam.
H beam rods vs i beam rods.
H beam is a stronger design when bending stress is considered davis said.
H beam connecting rods incorporate two large flat sides with a thin section in the middle.
With an h beam rod you should look at the thickness of the blades.
An h beam rod has two large flat sides that are perpendicular to the piston pin and crankshaft journal with a thin center.
So performance i beam rods are typically made of a higher grade of steel 4340 or 300m and often have a thicker cross section in critical areas to increase strength.
H beam rods have a completely different design.
H beam rods are more difficult to machine so they are often more expensive.
H beam connecting rods have some additional things you want to look at before you pull the trigger on a set according to norris.
I beam or h beam.
Depending on the material you would want at least 900 inch of thickness in that area.
This design makes these rods more rigid and able to handle compression forces.